From: flyn3nvt@adelphia.net
Date: Thu Feb 24 2005 - 11:10:25 PST
When I work on our Wright that is on our airplane (R760-8) I use Tight Seal.....good stuff
I have used permatex on my deuces is places and have been very happy.
Jeff in vt
---- "Mil-Veh Co." <milveh@sbcglobal.net> wrote:
> Here is the run down on Permatex products that might
> be helpful:
>
> Carbs...PERMATEX HIGH TACK GASKET SEALANT Temperature
> range -65F to 500F. Resists gasoline,oil,
> antifreeze,and axle lube.Good for valve
> covers,carburetor,fuel pump,and manifold gaskets.
>
> PERMATEX ULTRA COPPER Hi-Temp RTV Silicone Gasket
> Maker - Temperature range -75°F to 700°F intermittent;
> Good for Exhaust manifolds/headers, valve covers, oil
> pans, timing covers, water pumps, thermostat housings.
>
> PERMATEX ULTRA BLACK Gasket Maker - Temperature range
> -75°F to 625°F intermittent; Good for valve covers,
> oil pans, intake manifold end seals, timing covers,
> transmission pans.
>
> They also make a great sealant for plastic tanks and
> gas tanks.
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:39:53 PDT