Re: [MV] 12v M38A1

From: Thomas M McHugh (tmmchugh@msn.com)
Date: Tue Mar 01 2005 - 14:12:17 PST

Next message: Thomas M McHugh: "MILITARY TRANSPORT ASSOC. SHOW & SWAP MEET APRIL 2-3, 2005"
Previous message: Stephen L Dussetschleger: "Re: [MV] Half track armor dimensional drawings?"
Maybe in reply to: Buzz: "Re: [MV] 12v M38A1"
Next in thread: Everette: "Re: [MV] 12v M38A1"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Chris,

I have an M38A1 that is 12 volt & this spring I am converting it back to 24
volt. I have most of what I need.

Where are you located ??? Maybe we can swap some parts ???

Tom McHugh, NJ
1952 M38A1
M-416 Trailer
MVPA, MTA

----- Original Message -----
From: "Gray, Chris" <Chris.Gray@fmr.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, March 01, 2005 10:44 AM
Subject: [MV] 12v M38A1

HI Everyone - I'm rebuilding an M38A1 from the ground up. I'm thinking
of converting it over to 12v. Any thoughts on this? Is there anyone
out there that has done it before and could give me some tips, good and
bad.

Does anyone have a wiring diagram for the m38a1

Thanks
Chris

=Mil-Veh is a member-supported mailing list=
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>

Next message: Thomas M McHugh: "MILITARY TRANSPORT ASSOC. SHOW & SWAP MEET APRIL 2-3, 2005"
Previous message: Stephen L Dussetschleger: "Re: [MV] Half track armor dimensional drawings?"
Maybe in reply to: Buzz: "Re: [MV] 12v M38A1"
Next in thread: Everette: "Re: [MV] 12v M38A1"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:41:21 PDT