From: David Ashley (imjustdave@hotmail.com)
Date: Tue Apr 19 2005 - 12:33:49 PDT
I would think like a head on an engine.. build up the torque = on each one.
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On Behalf
Of Gray, Chris
Sent: Tuesday, April 19, 2005 12:24 PM
To: Military Vehicles Mailing List
Subject: [MV] M101a1 Bolt Torque Question
The axle U bolts on the M101a1 trailer. I have an old sheet that lists
the torque at 85ft lbs for the 1/2" fine thread. But with the U bolt,
would that be 85 on each side, or 40 and 40???
Does anyone know what the U bolts should be torque to or any other
tighten specs??
Chris
=Mil-Veh is a member-supported mailing list=
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:42:55 PDT