From: Roger Leete (rleete@localnet.com)
Date: Fri Apr 22 2005 - 16:58:31 PDT
Gotta be replaced, unless you can find the leak and solder it.
It's heating up, absorbing gas, and then it won't float. Throws the
adjustment out of whack.
----- Original Message -----
From: "Stu " <stuinnh@mvnut.us>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, April 22, 2005 7:52 PM
Subject: Re: [MV] Mutt Carb Problems
> What should I check it for? Adjustment? Replace?
>
> "Stu"
> Southern New Hampshire, USA
> "Live Free Or Die"
>
> MVPA #14790
> 1967 M151A1 Jeep
> 1964 M416 Trailer
> 1986 M1009 Blazer
>
>
> -----Original Message-----
> From: Chris Brunner [mailto:cjbrunner@optonline.net]
> Sent: Friday, April 22, 2005 7:51 PM
> To: Stu Ellis
> Subject: Re: [MV] Mutt Carb Problems
>
> check your float valve
>
> Stu Ellis wrote:
>
>>Hi all!
>>If I turn off the engine of the Mutt for a short time, and try to start it
>>again it floods. This has got worse over time. Any idea what may be
>>causing it?
>>
>>
>> "Stu"
>>Southern New Hampshire, USA
>> "Live Free Or Die"
>>
>>MVPA #14790
>>1967 M151A1 Jeep
>>1964 M416 Trailer
>>1986 M1009 Blazer
>>
>>
>>
>>
>>===Mil-Veh is a member-supported mailing list===
>>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>>To reach a human, contact <ack@mil-veh.org>
>>
>>
>>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:42:55 PDT