From: Bruce C. Beattie (bruce@EECS.Berkeley.EDU)
Date: Sat Jun 04 2005 - 21:08:59 PDT
Just take it in to your local automotive machinest. It doesn't matter
what it is off of
but you may need to bring in the TM that gives the machining tolerances.
I think it is
stamped on the drum, but I'm not sure. The TM has the specs though.
Bruce MVPA 23824
Eric K Davis wrote:
>Has anyone had their brake drums machined? Is this something a local
>truck shop could do? I'm interested in opinions and experiences.
>
>Thanks!
>Eric
>Tucson, AZ
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 22:47:27 PDT