From: Rick v100 (rickv100@yahoo.com)
Date: Tue Jul 19 2005 - 06:11:41 PDT
Due to the warmth and general friendliness of the list
lately I knew it was best to send out a correction
before the usual amount of traffic was created that
never answers the orignal posters question.
Rick
--- m35products <m35prod@optonline.net> wrote:
> Nevermind.
>
> apb
> ----- Original Message -----
> From: "Rick v100" <rickv100@yahoo.com>
> To: "Military Vehicles Mailing List"
> <mil-veh@mil-veh.org>
> Sent: Tuesday, July 19, 2005 7:37 AM
> Subject: Re: [MV] MV gauge part needed
>
>
> > Should read clamps.
> >
> > Thanks,
> > Rick
> >
> >
> > --- Rick v100 <rickv100@yahoo.com> wrote:
> >
> > > Anyone happen to have any extra gauge camps?
> These
> > > are
> > > the sheet metal parts you attach to the back of
> the
> > > gauge for holding them in.
> > >
> > > I need one for a oil pressure gauge.
> > >
> > > Thanks,
> > > Rick
> > >
> > >
> > > ===Mil-Veh is a member-supported mailing list===
> > > To unsubscribe, send e-mail to:
> > > <mil-veh-off@mil-veh.org>
> > > To switch to the DIGEST mode, send e-mail to
> > > <mil-veh-digest@mil-veh.org>
> > > To reach a human, contact <ack@mil-veh.org>
> > >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:22:18 PDT