From: uniquemachine@cybcon.com
Date: Tue Jul 26 2005 - 12:29:11 PDT
A few special ones do, most don't.
Jon
Unique Machine & Engineering
On 26 Jul 2005, at 7:40, santoken@bright.net wrote:
> To the best of my knowledge, Helicoil doesn't use any type of standardized tap for their inserts. I could be wrong, I suppose.
>
> Kent
>
> >
> > From: machinehop5@hotmail.com
> > Date: Tue Jul 26, 2:32 AM
> > To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> > Subject: [MV] Helical Coiled Wire Inserts aka Heli-Coil t/m
> >
> > High Imformed Gang g=Green,
> >
> > Looking for Tap size or for Helically Wire Coil Taps from 4-40 to 1/2 anyone
> > have Dim's Thread Height, etc. SAE
> >
> > ..Thx in advance
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list==To unsubscribe, send e-mail to: <mil-veh-off@mil
-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:22:19 PDT