From: noel shelley (noel@shelley1722.freeserve.co.uk)
Date: Mon Aug 01 2005 - 14:45:28 PDT
Hi Jim,
Whilst SAE threads are what I would expect , it could be ¼" BSP
this would be an OD of 0.518 at 19 tpi .¼" NPTF at 18 is possible on short
engagement . ANY good hydraulics shop will fix you up with pipe and fitting
! SOME steel lines will crack due to vibration , even when clamped !
It`s not likely to be 14mm X 1.5 -----is it ?
Good Luck Noel
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:25:24 PDT