From: m35products (m35prod@optonline.net)
Date: Sun Aug 21 2005 - 13:21:38 PDT
I bought the rear-facing add-on from Sarafan Eq. It cost, at the time, $250.
I installed it on the rear of the winch PTO. The drive shaft of my hydraulic
pump/reservoir is fastened to the output shaft.
The hydraulic system can be used to power a dump body, snow plow, or other
hyd. eq.
apb
----- Original Message -----
From: "Sonny Heath" <sonny@defuniak.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, August 21, 2005 8:57 AM
Subject: Re: [MV] Rear PTO
> Aurthur,
>
> I still don't know how this PTO would be used on a 2 1/2 ton. Give me
what
> you use it for, I might need one on mine once I know.
>
> Thanks,
>
> Sonny
>
>
> ----- Original Message -----
> From: "m35products" <m35prod@optonline.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Saturday, August 20, 2005 2:09 PM
> Subject: Re: [MV] Rear PTO
>
>
> > Hi Earl:
> >
> > The rear-facing PTO is a small gearbox that mounts on the rear of the
> > existing forward-facing PTO, in place of the rear blank plate. The PTO
has
> > one speed, in one direction. It is lubricated via the front PTO, in turn
> > via
> > the transmission.
> >
> > I have not seen any handles for sale for these in a long while, and I
had
> > to
> > fabricate my handle out of 1.25" by 0.375" flat bar stock, with a pair
of
> > 45
> > degree offset bends. The handle engages/disengages the rear PTO
> > independently of the front PTO. It comes up through the floor in the
same
> > slot as the winch control handle, and slightly to its left. The bracket
> > that supports the winch handle also can be used to support the rear PTO
> > handle. I put a kid's bicycle handlebar grip on the handle to make it
> > look
> > purty.
> >
> > Expect to pay between $200 and $300 for a serviceable one. You will need
> > to
> > make a gasket or two, which are simple to make. The PTO may be available
> > from Roger at Army Surplus of Dodge City. 316-227-7441.
> >
> > Arthur P. Bloom, Pres.
> > www.M35products.com
> >
> > ----- Original Message -----
> > From: "Earl Beverly" <earlbeverly@gmail.com>
> > To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> > Sent: Saturday, August 20, 2005 1:24 PM
> > Subject: [MV] Rear PTO
> >
> >
> >> Hi All,
> >> I need a rear PTO for an M-35 A2. I am not familliar with it. I need
> >> to keep the front PTO for winch. Where does the rear PTO hook up?
> >> Thanks,
> >> Earl
> >>
> >> =Mil-Veh is a member-supported mailing list=To unsubscribe, send e-mail
> > to: <mil-veh-off@mil-veh.org>
> >> To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> >> To reach a human, contact <ack@mil-veh.org>
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
> >
> > --
> > Internal Virus Database is out-of-date.
> > Checked by AVG Anti-Virus.
> > Version: 7.0.338 / Virus Database: 267.9.6/59 - Release Date: 7/27/2005
> >
> >
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:25:29 PDT