From: m35products (m35prod@optonline.net)
Date: Mon Sep 05 2005 - 21:53:29 PDT
I meant why not cut it on a lathe? A lathe can also cut off.
apb
----- Original Message -----
From: <Recovry4x4@aol.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, September 06, 2005 12:49 AM
Subject: Re: [MV] Cutting a Transmission Input Shaft
> Lathe is a machine used to turn and machine various materials. Still need
to
> know about softening the steel with heat though!
>
> In a message dated 9/6/05 12:46:32 AM Eastern Daylight Time,
> m35prod@optonline.net writes:
>
> > Lathe?
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:27:03 PDT