From: archie road (jeep_32@mountain.net)
Date: Tue Sep 06 2005 - 00:30:45 PDT
Kenny,
I have a old rockwell 4" angle air grinder that i use 1/8th inch
thick abrasive discs on and it will cut something like that just fine,
almost as good as with a machine.
Recovry4x4@aol.com wrote:
>Here's a question for all you metalurgists and welders. I have an extra input
>shaft from a deuce transmission. I want to cut the gear portion off. Is there
>anyway to temper the steel with heat so that I can cut it with my bandsaw? I
>know I can chop it with the heat wrench but prefer the cleaner cut of the saw.
>Thanks,
>Kenny
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
>.
>
>
>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:27:03 PDT