From: Mike Maynard (mike@wesleyscott.com)
Date: Tue Sep 06 2005 - 07:37:34 PDT
I don't think Kenny is worried about heat on his input shaft. He just wants
the gear off of it to make a good clutch tool. His concern was that his
bandsaw might not want to cut the hardened metal. He will do just find with
an abrasive disk. Personally I think the gears make a great handle... ;-)
Mike
-----Original Message-----
From: Rick v100 [mailto:rickv100@yahoo.com]
Sent: Tuesday, September 06, 2005 10:39 AM
To: Military Vehicles Mailing List
Subject: Re: [MV] Cutting a Transmission Input Shaft
Why not just use some type of metalworking fluid as
coolant?
I think your original advice to go to a machine shop
is the best.
Cutting with even a thin abrasive disk is going to
cause a heat effected zone at the face of the cut at
the very minimum.
Rick
--- m35products <m35prod@optonline.net> wrote:
> Welding heats the work. We are talking about cutting
> and machining. When the
> temper of the work is critical, I imagine that there
> is an alternative to
> using heat, such as develpoed during welding, but
> perhaps an expert can
> enlighten us.
>
> A P No Expert At All Bloom
>
>
> ----- Original Message -----
> From: "SGM PANTANO" <TRUKS1@msn.com>
> To: "m35products" <m35prod@optonline.net>;
> <mil-veh@mil-veh.org>
> Sent: Tuesday, September 06, 2005 9:24 AM
> Subject: Re: [MV] Cutting a Transmission Input Shaft
>
>
> >
> > Does not equate.???? When welding -- do they use a
> "cold" weld...?? After
> > welding -- nothing beats quenching in oil..
> > Gene
> >
> > > Usually cutting or grinding will change the
> temper of the metal. That is
> > > why
> > > it's important not to heat the work.
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to:
> <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:27:03 PDT