From: MV (MV@dc9.tzo.com)
Date: Fri Nov 18 2005 - 08:00:47 PST
I'm not sure what you are referring to, but if you replace the main
caps, you normally have to have the engine line bored.
If you are looking for max strength, studs are hard to beat. I bet ARP
sells a set that would work for the 6.2.
Dave
Joe Foley wrote:
> My crystal ball tells me that the main bearing caps on
> the 6.2/6.5 were too weak, new ones are in the offing,
> ASAP! Version 2 wasn't much better, they tried to
> re-use bolts that were too short.
>
> Version 3 has been offered.
>
> So, if you're rebuilding an engine be patient and
> wait.....
>
> Joe
>
>
>
>
>
>
> __________________________________
> Yahoo! Mail - PC Magazine Editors' Choice 2005
> http://mail.yahoo.com
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
> To reach a human, contact <ackyle@gmail.com>
> Visit the searchable archives at http://www.mil-veh.org/archives/
>
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:32:02 PDT