From: V SCHWARTZ (vsaws@optonline.net)
Date: Wed Dec 07 2005 - 04:28:40 PST
Adam, how do you know that the sprag isn't working? As far as I know , the
thing works only when there is a 2% slippage on the rear drive.
----- Original Message -----
From: "Adam Suess" <ajsuess@hotmail.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, December 06, 2005 11:46 PM
Subject: [MV] 5 Ton transfer case sprag replacement?
> Hello,
> I have two 5 tons that apparently need sprag replacement. Front axle only
> pulls in reverse. The air shift is working or at least it is as best I can
> tell. How bad is it to change out? Do I need to get into preloading
> berrings or need dial calipers? Trucks are M54A1 and XM813. Thanks much.
> Adam Suess
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
> To reach a human, contact <ackyle@gmail.com>
> Visit the searchable archives at http://www.mil-veh.org/archives/
>
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:36:56 PDT