From: G Shaw (milspectruck@verizon.net)
Date: Fri Dec 16 2005 - 09:45:18 PST
If you bypass the ballast resistor then you should use the humvee plugs
which are 24 volt but they use the bullet connector. If you put the ballast
resistor back in line then just go with the non swelling AC Delco AC-60G.
No problems after that. Kascar has Humvee glow plugs for 24 volt that are
also non-swlling but they are $$$. The orig is the AC-13G but they are
obsolete design.
Glenn
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On Behalf
Of willys1966
Sent: Friday, December 16, 2005 12:27 PM
To: Military Vehicles Mailing List
Subject: [MV] M1009 Glow Plugs
Need to know the correct glow plugs for my M1009 it
currently
has AC 13G's installed also the resistor bank is bypassed
does
that make a difference in what type of plug is used.
Thanks for any help, Scott
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
To reach a human, contact <ackyle@gmail.com>
Visit the searchable archives at http://www.mil-veh.org/archives/
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:37:09 PDT