From: Bruce C. Beattie (bruce@EECS.Berkeley.EDU)
Date: Wed Dec 21 2005 - 18:40:08 PST
VERY good point!
Bruce
m35products wrote:
>Don't drill through the freon lines in the top, sides, or bottom of the
>freezer compartment.
>
>
>----- Original Message -----
>From: "bruce C. Beattie" <bruce@eecs.berkeley.edu>
>To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
>Sent: Wednesday, December 21, 2005 6:37 PM
>Subject: Re: [MV] GPS and Sandblasting
>
>
>
>
>>I believe someone suggested getting an old refrigerator. Should be easy
>>to find just about free.
>>Get some copper tubinig.
>>drill two holes in the freezer compartment, one one either side.
>>Coil up the coper tubing and insert in the freezer.Orient the tubing
>>coil so that any water will drain to the discharge line and not just sit
>>in the coil when not being used.
>>stick the ends out the two holes
>>Put fittings on the tubing and attach a quick connect air adapter pair
>>on the two fittings
>>squeeze some silicon glue in the holes to seal up the air leaks.
>>
>>
>>If you want to get fancy, put a "T" in there and an automatic drain.
>>
>>List: Feel free to make corrections if necessary....
>>Bruce MVPA 23824
>>
>>
>>laptops wrote:
>>
>>
>>
>>>I have a unusual GPS on ebay now for cheap money ebay number
>>>4599155900 this was some kind of a mil surplus item
>>>I have some sand blasting comeing up and I remember on this list about
>>>cooling the air going to the air compressor so it will not over
>>>heat.Anybody got a simple way to do this without building something
>>>special
>>>Gordon
>>>
>>>===Mil-Veh is a member-supported mailing list===
>>>To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
>>>To reach a human, contact <ackyle@gmail.com>
>>>Visit the searchable archives at http://www.mil-veh.org/archives/
>>>
>>>
>>
>>===Mil-Veh is a member-supported mailing list===
>>To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
>>To reach a human, contact <ackyle@gmail.com>
>>Visit the searchable archives at http://www.mil-veh.org/archives/
>>
>>
>
>
>
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:37:16 PDT