Re: M1009 CUCV problem

From: Mark B. Anderson (mark@aasurplus.ca)
Date: Mon Mar 20 2006 - 19:53:43 PST


Hi all,

just finished getting back on the road.

used the NAPA number and my parts guy had one in stock $15.00 CDN after
taxes.
replaced it replaced burnet wire.
stood back and watched NO smoke LOL.

everything seems good and starter is OK..

so lots of panic for a 15.00 part.

Thanks again to everyone for the help.

Mark
----- Original Message -----
From: "Mike Howell" <
doctormv@frontiernet.net>
To: "Mark B. Anderson" <mark@aasurplus.ca>; "Military Vehicles Mailing List"
<mil-veh@mil-veh.org>
Sent: Monday, March 20, 2006 9:21 PM
Subject: Re: [MV] M1009 CUCV problem

> Mark, you never did tell us what the final diagnosis was. Since you
> needed the part number for the starter relay, I am guessing that was the
> problem. But then it sounded more like a dead short to ground than a bad
> relay to me.
>
> Mike
> Tishomingo, MS
>
> Mark B. Anderson wrote:
>
>> Hi all,
>>
>> went to start my M1009 this morning.
>> ok manual glowed plugs truck turned over but never started tried again
>> and then there was smoke. lifted hood both batteries were melting and the
>> wires were on fire.
>>
>>
>>
>>
>>
>



This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:42:39 PDT