From: James Shanks (n1vbn@yahoo.com)
Date: Sun Apr 02 2006 - 00:01:38 PST
Did you install the starter with the shim or
without? The CUCV requires a shim for correct
bendix engagement.
Jim
1985 M-1009
--- "Dennis M. Hankey" <dmhankey@grandcounty.com>
wrote:
> TO ALL:
> Stumper of the week!! Installed new ring gear.
> Started many times after
> that just fine. Now sometimes from time to
> time there is a heck of a noise,
> something slipping , no engagement, no
> starting. Removed starter cleaned,
> replaced starter lever as the ears were warn
> and there was an indication the
> gear was not fully engageing. Noticed some
> nicked ring gear teeth. Open
> solanoid, inspecteded and reversed the round
> contact plate. Reinstalled,
> started many times there after ok. Now three
> days later again same problem.
> Removed starter and replaced starter driver
> with new part. Noticed more
> nicks on ring. On fifth start same problem.
> Could it be that the solanoid
> starts the starter turning before the gear is
> engaged?? Any answers on what
> I'm missing here??
> Thanks Dennis Hankey M1009
>
>
> ===Mil-Veh is a member-supported mailing
> list===
> To unsubscribe, send e-mail to
> <mil-veh-off@mil-veh.org>
> To reach a human, contact <ackyle@gmail.com>
> Visit the searchable archives at
> http://www.mil-veh.org/archives/
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:43:30 PDT