Military-Vehicles: Re: [MV] Dual master cylinder conversion for M37 ???
Re: [MV] Dual master cylinder conversion for M37 ???
Rick (rickl@npark.com)
Wed, 23 Jul 1997 14:13:24 -0400
The problem with a dual master cylider changeover is that the master
cylinder bolts to the running board bracket. This places the master
cylinder on the outside of the frame rails. The stock master cylinder
has an armored brake line from the rear of the master cylinder to the
frame rail where a T fitting is installed through a hole in the frame.
If you change to a dual master cylinder you have to solve how to pass 2
lines through the frame rail to the brake lines on the other side. I am
not comfortable with either drilling a new hole in my frame for another
fitting or passing the line above and over the frame rails where it
could be damaged.
Just my two cents worth,
Rick
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.