Ooops, I just noticed that I made a MISTAKE in a paragraph discussing recentering a brake
system differential pressure switch.
It previously read:
"After repairing any problem in the failed circuit, turn the electrical system on, loosen
a bleeder screw in the circuit that had failed, then press gently on the brakes until the
failure light goes out on the dashboard, retighten the bleeder screw, and release the
brake pedal. Done."
It should read:
"After repairing any problem in the failed circuit, turn the electrical system on, loosen
a bleeder screw IN THE CIRCUIT THAT HAD NOT FAILED, then press gently on the brakes until
the
failure light goes out on the dashboard, retighten the bleeder screw, and release the
brake pedal. Done."
This will push the piston back in the opposite direction, towards center.
Alan
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.