Military-Vehicles: Re: [MV] Re : Connecting rod installation problem

Re: [MV] Re : Connecting rod installation problem

MVBOATNUT@aol.com
Wed, 10 Sep 1997 21:29:27 -0400 (EDT)

I stand corrected. My original copy of TM-10-1207, the maintenance manual for
the MB slatgrill, goes in to more detail then TM 9-1803A. It states,"When the
rod is installed in the engine, the offset is away from the nearest main
bearing. The oil spray hole in bearing end of rod should be on the follow
side or away from the camshaft, toward the right side of vehicle."
If you follow the instructions given in fig. 36 of TM9-1803A concerning the
position of connecting rod off-set, that is, the short end being away from
the nearest main bearing, the squirt hole position should fall in line.

Andy LaBorde

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.