The only M715 I have seen this on is the M724 Contact Maint. Truck, and the
throttle control was used to regulate engine speed for the welder mounted in
the rear. It was powered by a power take-off on the rear driveline. U have one
of these trucks, but unfortunately, the linkage was removed from the carb.
when I got it. There is no where on the stock carb/governer set-up to attach
this hand-throttle, so I can only assume that there was a add-on by the carb
for these trucks. I would be interested in knowing too. Any M724 Contact
Maint. Truck owners out there???
Erik Timothy
Federal Way, WA
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.