There are no locking hubs for an M151. They cannot be used due to the design of
the spindle/bearing assy. This assy was never made to have a locking hub
installed. It is essentially inside out compared to a regular straight front
axle. The spindle (if you would call it that) is stationary and the outer race
is inside of it. The axle shaft pass thru the spindle and has the inner races
on it. The bearings and axle shaft support the weight of the vehicle.
Hope this helps
Steve
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.