re: [MV] Re:M135 Question

BATHRICK@sandiego.hcg.com
Wed, 06 May 98 13:59

To the best of my knowledge, the M135 never had a dump version. The 211 did
but I can't think of the number, possibly M217, but without the service
manual I can't say for sure. At any rate, there were two of the three that
could be used with the dump, which did drive a hydraulic pump. There was a
pto with a rear output and one with both a rear and front output, for those
dump trucks with winches. I have the later and will install it on mine when
I find a winch, but I have a few other issues to address before I travel
down that road.

Thanks,
Sean
MVPA 14222
53 M38A1
51 M135
67 M416
-------------
Original Text
>From mail@IH (Harry Arana){carana@pacific.net}, on 5/6/98 10:33 AM:
Hi everyone,
I wanted to know from anyone out there what type adapter and pump
set-up, I should use for a M 135 6x6. It has a front winch (pto). I
am installing a dump bed.
I have seen the aux. output shaft that mount on top of the pto. Is
there a pump that works with this set-up? What did the original M135's
that had front winches and dumps or hydrolics use ?
Harry

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.