[MV] NP201 parts

Robert H. Clugston (robert@csnsys.com)
Thu, 14 May 1998 13:09:53 -0700

List,
Does someone know where I can get a "Thrust Washer" for a NP201 transfer
case. I am having my transfer case rebuilt and the guy ran out of these. I
have had my truck in the shop for about 2-3 weeks because we can't find one
of these. Everyone says, "oh ya I've got one of those in a bucket...I'll
send it right too you." Then they go look in that bucket and its not there
or it's for a NP205.
This is the washer that is used to hold in the needle bearings.
The washer is about 1/8" thick, 2 5/16" Outside Diameter, 1 13/16" inside
Diameter, with about 1/32" spleens on the inside. It is made out of harden
steel. Note: the NP205 thrust washer doesn't have these spleens.
If someone has one of these is a bucket can they PLEASE find it and send me
a response.

The NP201 was used on the M-715 truck and some International's. It has the
rear drive shaft off set to the right compared to the NP205 which is a
straight line.

Thanks in advance,
Robert
robert@csnsys.com

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.