>>Does anyone on the list know a correct clutch alignment tool. Are
>>there any civilian versions available at NAPA or other parts stores?
>There will be a wide selection of civilian tools available at a good NAPA.
>You just need to know the number of splines and diameter of the shaft. An
>alternative would be an old input shaft from the same model trans.
>
Hi All,
I have used any old bit of steel bar, alloy bar or even a bit of broken
broom handle suitably turned (or whittled) to the appropriate diameters,
don't see why you have to worry about the splines at all. . . . . .unless
you have a twin plate clutch.
Richard
(Southampton UK)
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.