[MV] M38A1 Rear Axle Shaft Removal

Fitzpatrick (pfitzpatrick@snet.net)
Fri, 22 May 1998 10:01:37 -0700

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Henry J. Fackovec: "[MV] M.U.T.T.s"
Previous message: ANDERSONS: "[MV] 2-USMC M274a5 mules"

In order to replace an inner axle seal shaft I've removed hub and
brakes.
The TM says use a "suitable puller" to pull the shaft from the tube.
What is the suitable puller? I want to repack the bearing, too, but I'm
stuck. I rented a wheel puller to remove the hub.
Thanks in advance.

Paul Fitzpatrick
52 M38A1

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Henry J. Fackovec: "[MV] M.U.T.T.s"
Previous message: ANDERSONS: "[MV] 2-USMC M274a5 mules"