[MV] Paint removal on Ferrets

• Messages sorted by: [ date ][ thread ][ subject ][ author ]
• Next message: Bob & Jeff Gallagher: "[MV] Rokon 2 wheel drive motorcycle"
• Previous message: Mark R.: "Re: [MV] brakeshoe pliers and jacks..."
• Next in thread: JOHN SEIDTS: "Re: [MV] Paint removal on Ferrets"

I recently purchased a semi-restored Ferret M2/3. The interior was repainted
and all the dataplates, switchboard panel markings, smoke discharger markings,
etc. were covered over with a thick coat of paint.

I just discovered that the transmission had a nice brass plate with all sorts
of info about the transmission and rework dates. However, it was obliterated
by paint.

Any suggestions on how I can remove the paint and not the informaiton below
it?

I have tried paint stripper in small stages, using rags to soften and rub off
a fine layer at a time. But this is very tedious.

Thanks,

Ken Fieth
Nashville, TN
USA

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

• Next message: Bob & Jeff Gallagher: "[MV] Rokon 2 wheel drive motorcycle"
• Previous message: Mark R.: "Re: [MV] brakeshoe pliers and jacks..."
• Next in thread: JOHN SEIDTS: "Re: [MV] Paint removal on Ferrets"