Re: [MV] Trailer straightening
DBaumanjr@aol.com
Mon, 27 Jul 1998 17:56:49 EDT
In order to straighten your trailer frame, you'll need to tie the high
corners down & jack the low corners up. Any body shop could do it in no time.
You could try putting the high corners under the bumper of a heavy vehicle &
then put one low corner on a jackstand ( not the cheapie,junk ones) & jack up
the other low corner. Remember that the frame will spring back a bit upon
release of tension. It'll all be trial & error, good luck & BE CAREFUL!!!
Darryl Bauman Jr
MVPA
M-718 (m-151 1/4 ton jeep 4x4 frontline ambulance) (whew!)
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.