the spindle, then a washer to support the felt washer, then another washe=
r
to support the other side of the felt washer and then the bearing race. =
Since the bearing race is shot already, it certainly sounds like you will=
have to pull the race off in order to get the felt washer off. Some heat=
=
would probably help get the race off but screw up the felt. If you can
save the washers?? (not destroy them) and get race off, remove the
washers/felt/ etc. Cut some new felt, possibly stack it up to get the
thickness, and reinstall it?? That sounds like the only reasonable
solution to me. =
Dave =
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.