Re: [MV] heater wiring

Jeff Smith (mvpc@gte.net)
Tue, 5 Jan 1999 14:32:21 -0600

I found the Diagram from a Manual and scaned it. it is at
www.mvpc.com/heat.jpg and also another picture at www.mvpc.com/heat1.jpg

hope this helps
Jeff Smith M*V*P
WWII & M-Series Wiring Harnesses
Pensacola, FL.
www.mvpc/com

-----Original Message-----
From: Buzz <buzz@lanset.com>
To: Baltz, Tim <baltzt@Brentwood-tn.org>
Cc: 'mil-veh@skylee.com' <mil-veh@skylee.com>
Date: Monday, January 04, 1999 11:52 PM
Subject: Re: [MV] heater wiring

>Tim,
>The wire from the fan goes to the center terminal (swinger) of the
>switch. The resistor connects to the outer terminals of the switch. A
>switched, circuit breaker protected, power wire from the ignition switch
>connects on the "low" end of the switch with one of the resistor leads.
>To get a power wire you might have to splice into and existing wire or
>use a "Y" tap if you have one in the kit.
>Good Luck,
>Buzz
>
>
>"Baltz, Tim" wrote:
>>
>> Hi list;
>> Does anyone have the wiring diagran for a Hunter MFG Co. Cleveland OH,
>> 24 volt Model HW20-2. I have the kit but no wiring diagran. It's a
>> universal kit made in about 1978 Thanks Tim
>>
>> ===
>> To unsubscribe from the mil-veh mailing list, send the single word
>> UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.
>
>
>"Baltz, Tim" wrote:
>>
>> Hi list;
>> Does anyone have the wiring diagran for a Hunter MFG Co. Cleveland OH,
>> 24 volt Model HW20-2. I have the kit but no wiring diagran. It's a
>> universal kit made in about 1978 Thanks Tim
>>
>> ===
>> To unsubscribe from the mil-veh mailing list, send the single word
>> UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.
>
>
>"Baltz, Tim" wrote:
>>
>> Hi list;
>> Does anyone have the wiring diagran for a Hunter MFG Co. Cleveland OH,
>> 24 volt Model HW20-2. I have the kit but no wiring diagran. It's a
>> universal kit made in about 1978 Thanks Tim
>>
>> ===
>> To unsubscribe from the mil-veh mailing list, send the single word
>> UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.
>
>
>"Baltz, Tim" wrote:
>>
>> Hi list;
>> Does anyone have the wiring diagran for a Hunter MFG Co. Cleveland OH,
>> 24 volt Model HW20-2. I have the kit but no wiring diagran. It's a
>> universal kit made in about 1978 Thanks Tim
>>
>
>===
>To unsubscribe from the mil-veh mailing list, send the single word
>UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.