Re: [MV] Timing light adapter for M151's

Buzz (buzz@lanset.com)
Fri, 15 Jan 1999 18:36:53 -0800

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Winne, Jim: "Re: [MV] Timing light adapter for M151's"
Previous message: Alan Zeichner: "[MV] Timing light adapter for M151's"
Maybe in reply to: Alan Zeichner: "[MV] Timing light adapter for M151's"
Next in thread: Winne, Jim: "Re: [MV] Timing light adapter for M151's"

I picked up a used spark plug wire at a swap meet for a few bucks then
removed a section of the braid. When necessary I just swap out the
existing wire.
Buzz

Alan Zeichner wrote:
>
> Just had the opportunity to us an adapter that attached to the end of my steel braided spark plug wire to allow me to use a clamp on timing light . Does anyone know where I might find one to buy. The one I used cost the owner $5. Any help would be appreciated......Alan
>
> ===
> To unsubscribe from the mil-veh mailing list, send the single word
> UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Winne, Jim: "Re: [MV] Timing light adapter for M151's"
Previous message: Alan Zeichner: "[MV] Timing light adapter for M151's"
Maybe in reply to: Alan Zeichner: "[MV] Timing light adapter for M151's"
Next in thread: Winne, Jim: "Re: [MV] Timing light adapter for M151's"