[MV] MV Drive Shaft question

Rob and Carol Jenkins (jenkins58@ii.ca)
Sat, 23 Jan 1999 11:31:57 -0800

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: David Robinson: "[MV] WW2 Dodge Motor Pool Updated"
Previous message: Richard Van Hoomissen: "[MV] F head 134 cu inch engine; Rick's Ready Repair"
Next in thread: Greg David: "RE: [MV] M101A1 tread width"

Re #2: originally driveshafts were assembled at SPICER with U-joint cups
tacked on so as not to lose them on the assembly line before installation.
Replacements do not have this tin tab.

I went to the local Ford parts dept. and bought part #C3AZ-4635-J, it fit
perfect. Its a pretty standard U-joint (also fits my Edsels).

Rob Jenkins
'42 GPW
'58 Edsels

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: David Robinson: "[MV] WW2 Dodge Motor Pool Updated"
Previous message: Richard Van Hoomissen: "[MV] F head 134 cu inch engine; Rick's Ready Repair"
Next in thread: Greg David: "RE: [MV] M101A1 tread width"