Any ideas on how to pull the front axle seals? These are the seals
located _behind_ the innermost thrust washer, and are accessible
after pulling out the front drive axle(s). They're a _big sucker_ ,
almost 4" in diameter. I'm told by our Army buddies at the Direct
Support facility that it takes a special air-powered tool to remove
and install them. Anybody got any alternatives? (Hint: A pilot
bushing removal tool and slide hammer WON'T get it!)
Dave Barbieri
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.