[MV] RE Replacing bearings

Dr Deuce 264-0909 (keith@apache.ENET.dec.com)
Thu, 25 Feb 99 06:48:24 EST

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Glenn Shaw: "Re: [MV] AN PRC-77"
Previous message: vilgos@juno.com: "[MV] AN PRC-77"

One thing I do is save one set of old outer races and grind flat spots on them
so they will not 'stick' inside the housing anymore. You can then use them to
pound or press in the new races below them without damaging the new ones.

Steve

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Glenn Shaw: "Re: [MV] AN PRC-77"
Previous message: vilgos@juno.com: "[MV] AN PRC-77"