Re: [MV] Drive line vibrations in Willys MB?

MVTrucker@aol.com
Wed, 10 Mar 1999 08:01:16 EST

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: OConnor, Dennis: "RE: [MV] Starter Problems in L134 engine"
Previous message: Jerry Cleveland: "[MV] Fwd: re restoration of jeep"
Maybe in reply to: Brent McClearen: "[MV] Drive line vibrations in Willys MB?"
Next in thread: DBaumanjr@aol.com: "Re: [MV] Drive line vibrations in Willys MB?"

Brent,
You mentioned new U-joints. These have to be installed"in time" with
each other. If they're "out of time", vibration results. I read an article
about this quite a while ago and I'm not sure of the correct installation.
It's about how the joints line up with each other. Hopefully, someone on
the list can explain it. As was mentioned by someone else, a bent
shaft will vibrate.
Joe mvtrucker@aol.com

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: OConnor, Dennis: "RE: [MV] Starter Problems in L134 engine"
Previous message: Jerry Cleveland: "[MV] Fwd: re restoration of jeep"
Maybe in reply to: Brent McClearen: "[MV] Drive line vibrations in Willys MB?"
Next in thread: DBaumanjr@aol.com: "Re: [MV] Drive line vibrations in Willys MB?"