[MV] 151a2 exhaust manifold

Dr. R. E. Roberts (drrick@wcc.net)
Wed, 28 Apr 1999 14:25:31 -0500

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Ron: "Re: [MV] Weight of a 57mm AT gun"
Previous message: William R. Benson: "Re: [MV] (jerry-) gas can"

I have a small sputter from the exhaust manifold and the pipe shaped
part is slightly to the rear in the fitting on the block. How much of a
bag of worms is it to adjust , tighten or replace gaskets on this
beast. I have to drill out a few busted studs on the outer flanges
anyway.

rick roberts

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Ron: "Re: [MV] Weight of a 57mm AT gun"
Previous message: William R. Benson: "Re: [MV] (jerry-) gas can"