RE: [MV] T214 Motor in WC54

OConnor, Dennis (DOconnor@SIKORSKY.COM)
Wed, 19 May 1999 16:03:09 -0400

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Gordon.W.I. McMillan: "Re: [MV] T214 Motor in WC54"
Previous message: Dan Bever: "[MV] Combat Jeep wheels"

>WC 54 motor last ran last summer. Had all new plug wiring, coil, etc.,
>but still wouldn't hit. Set distributor as per manual with timing mark >on
top dead center etc. but still wouldn't hit. Backfired and spit a >lot, but
wouldn't run.

Just a stray thought...how far did you turn the distributor? This sounds
like when I put small block Chevy distributors in 180 degrees from where it
belongs. Common problem.

Dennis O'Connor

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Gordon.W.I. McMillan: "Re: [MV] T214 Motor in WC54"
Previous message: Dan Bever: "[MV] Combat Jeep wheels"