Re: [MV] M38A1 Distributor Problem
Lisa (jeepcj8@home.com)
Mon, 19 Jul 1999 21:18:16 -0700
Will-
Yep, it's a Jeep trick. When I bought a dist for my M38, the
seller had sage advice on install:
Cylinder #1 at TDC
When inserting the dist, the rotor should point to #1
terminal WITH THE POINTS JUST BEGINING TO OPEN. That's the
trick. You may have to remove the dist and get in there with
a screwdriver to reorient the slot where the dist shaft goes
in. He warned me that if I did not get this right I would
run out of room to adjust. Give this a try--I am anxious to
know if it works..in theory it should.
Good luck,
Lisa
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.