[MV] M35 distributor

Todd and Audrey Hall (athall@wavecom.net)
Wed, 25 Aug 1999 20:43:33 -0700

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Jon Shoop: "Re: [MV] wanted"
Previous message: Jim Rice: "Re: [MV] MRE's"
Next in thread: Gordon.W.I. McMillan: "Re: [MV] M35 distributor"

Hello all
Just finished rewiring my M35, 1952, Gas. Before I started that it
was getting hard to start.
Now there is no spark. Have replaced points and condenser, cap and
rotor. 24 volts is getting to the
coil resistor in the distributor, from the resistor there is only 5
volts getting to the coil.
Tried switching coil resistors, and had only 4 + volts to coil. How
much voltage should be
getting to the coil? Any Ideas what the problem could be? If the coil
resistor is bypassed
what would burn up first? Any help would be appreciated.
Todd Hall
Powell WY

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Next message: Jon Shoop: "Re: [MV] wanted"
Previous message: Jim Rice: "Re: [MV] MRE's"
Next in thread: Gordon.W.I. McMillan: "Re: [MV] M35 distributor"