RE: [MV] RE: MV brake bleeders

Keith, Steve (Steve.Keith@compaq.com)
Mon, 30 Aug 1999 13:53:45 -0400

Some people take a small piece of rubber hose and fill it with grease and
force it onto the bleader nut to completely cofer it so that the 6 sides are
protected and the base where it goes into the housing is too.

I second or third the recommendation for never-sieze on the bleader and
hose/tubing. Also, on the tubing going to the cylinder, slide the fitting
back from the double flair and put some never-sieze on that then running the
fitting up to the flair and wipe off the excess. It is not too good if the
fitting backs out of the cyl OK only to twist off the tubing...

Steve

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.