Re: [MV] Temperature Sensor on MB/GPWs

Gordon.W.I. McMillan (gwim2@student.open.ac.uk)
Tue, 19 Oct 1999 19:41:15 +0100

There isn't much of the thread actually goes into the head from that
fitting. I took the head off when fac ed with the same problem, but now
I'd just put a 1/8" drill through one side of the remaining metal and
chisel it out (carefully)

Reproduction temperature guages are available and are the one part where
the repro quality appears as good as the original, put the old one in a
box on the shelf though. gauge cost in the UK is about USD 60 equivalent
but it's worth it.

Gordon

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.