[MV] shielded wiring

From: DES COWIE (drcowie@logicworld.com.au)
Date: Thu Dec 23 1999 - 21:08:47 PST


*This message was transferred with a trial version of CommuniGate(tm) Pro*
Hi Guys

Restoring a1943 military vehicle with damaged shielded cabling from the voltage regulator
to the generator (to shield from interference to radio). Can anyone advise source of replacement
in Australia or US

In 2 sizes -

        3/8" outside diameter & 1/2" outside diameter

        both of braided (platted) tinned copper strands over a brass spiral inner sheath
        - the actual wiring cables are pulled through to suit

I need about 2.5 metres of each size for this project, but could use more

drcowie@logicworld.com.au
Federal 6x4 tractor
M3 light tank (Stuart)

==Mil-Veh is a member-supported mailing list=To unsubscribe, send e-mail to: <mil-veh-off@uller.skylee.com>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@uller.skylee.com>
Send administrative queries to <mil-veh-request@uller.skylee.com>



This archive was generated by hypermail 2b29 : Wed Jan 05 2000 - 22:42:32 PST