*This message was transferred with a trial version of CommuniGate(tm) Pro*
> List,
>
> I recently got a new gas tank for my 1945 MB Jeep. When I got the Jeep,
> it had an early CJ version tank with the filler neck out the side. Also,
> the whole underside of the body needed to be restored, so none of the
> original gas tank attachment hardware was in existence. I made great
> progress with the body and am ready to put in the new gas tank I got for
> Xmas. However, I have several questions:
>
> (1) What is the proper mechanism to hold the tank in place? From photos I
> can tell there is a band that goes across --> Is there only one band?
> Where and to what does this band attach to on each side? Are there any
> friction pads that are supposed to go between the tank and the body/tank
> well? Any idea where I can get these and what part(s) by name should I ask
> for?
>
> (2) I have also seen some rock/dirt guards that are to go around the tank
> --> Are these original configuration? Where do they go? How are they
> held in? Any idea where I can get these and what part(s) by name should I
> ask for?
>
> (3) On the list in the past, several of you discussed the benefit of
> putting a sealer in the tank --> What type sealer should I get? Any Ideas
> who carries this sealer? Any guidance/instructions on how to coat the
> inside of this tank?
>
> Thanks in advance, Herb
> ______________________________
> Herbert Brown
> hbrown@ida.org
> Institute for Defense Analyses
> 1801 N. Beauregard St.
> Alexandria, VA 22311-1772
> Phone (703) 845-6663
> FAX (703) 845-6788
>
>
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@uller.skylee.com>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@uller.skylee.com>
Send administrative queries to <mil-veh-request@uller.skylee.com>
This archive was generated by hypermail 2b29 : Wed Jan 05 2000 - 22:42:37 PST