*This message was transferred with a trial version of CommuniGate(tm) Pro*
Andy
The pin in my MB came out towards the brake drum. They can be assembled either way, so you should clean the ends of the pin until you can see the flat. Once I had the tapered pin out, I was unable to remove the bell crank shaft. I am going to try a hydraulic puller next.
Dave Fillman
45 MB
---- you wrote:
> Anyone got any helpfull hints on how to drive out the tapered pin that holds
> the pivot arm (bell crank) shaft to the front axle of the MB?
> Which direction does it come out? Towards the pumpkin or towards the brake
> drum?
>
> Andy LaBorde
> MB 102223 12/4/41
----------------------------------------------------------------
Get your free email from AltaVista at http://altavista.iname.com
This archive was generated by hypermail 2b29 : Mon May 01 2000 - 05:30:07 PDT