Re: [MV] RE Body thickness

• Next message: polarbears: "Heads up in Sweden?"
• Previous message: Mike Towers: "Re: [MV] Lead-fill body work."
• Next in thread: Richard Notton: "Re: [MV] RE Body thickness"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

If anyone needs a sheet metal thickness chart, there's a nice one at

http://www.eagle.ca/~ucs/2carb.html

Hope this helps.

Ken

----- Original Message -----
From: <Muttguru@aol.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, November 24, 2000 6:17 AM
Subject: [MV] RE Body thickness

>
> Dear Listers,,,,,
>
> a friend has asked about the thickness of the metal on the M151-series
body.
> The TM shows thicknesses in "0.000" scales........., how do we convert
these
> to "gauge"...... as in 14s gauge, 16s gauge etc....??
>
> Thanks gang..
>
> ken
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>

• Next message: polarbears: "Heads up in Sweden?"
• Previous message: Mike Towers: "Re: [MV] Lead-fill body work."
• Next in thread: Richard Notton: "Re: [MV] RE Body thickness"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Sun Dec 03 2000 - 20:29:57 PST