Correct thinner for Gilespie primer?

From: John A. Hern Jr (hern@nidlink.com)
Date: Mon May 14 2001 - 06:42:16 PDT

Next message: Jim Winne: "RETURN OF THE 3-WHEELED JEEP"
Previous message: Jon Huddleston: "OD Jamboree in Colorado this weekend"
In reply to: Chris Davis: "Carryall Restoration / Primer Problems"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

I've got a lot of frame parts ready for primer this weekend; I have a
gallon of red primer from RAPCO, but am not sure of the correct
thinner. Was planning on using xylene. It's in the 60's and 70's up
here in Idaho, hopefully the humidity will be low. I'm planning on
using a low pressure gun.

Any comments on thinner, viscosity / thinning, gun, technique, etc?

Thanks,

John

John A. Hern Jr. 1900 Millview Coeur d'Alene, Idaho 83814
mailto:hern@nidlink.com Dipl.Ing. Mechanical Engineer
Foundry: http://www.hernironworks.com
Greyhounds: http://www.greyhoundpetsinc.org
Personal: http://www.happygreyhound.com

Next message: Jim Winne: "RETURN OF THE 3-WHEELED JEEP"
Previous message: Jon Huddleston: "OD Jamboree in Colorado this weekend"
In reply to: Chris Davis: "Carryall Restoration / Primer Problems"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Jun 05 2001 - 23:18:35 PDT