Re: [MV] Multifuel compressor pulley slipping

From: Mark J. Blair (mblair1@home.net)
Date: Mon Nov 12 2001 - 09:30:21 PST

Next message: Steve: "[MV] M35 wire"
Previous message: uniquemachine: "Re: [MV] Multifuel compressor pulley slipping"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

"uniquemachine" <uniquemachine@air1.net> wrote:
> I know that this might sound kind of dumb, but it is something to
> check---How much NON-threaded length (shank)do you have on your
> pinch bolts? are the bolts really tightening up, or are you just
> bottoming out when they run out of thread to tighten up any more?

DOH! I'll feel really lame if that's the problem and I didn't catch
it. I'll check into that possibility, too.

Thanks for all of the suggestions! I won't know what's really wrong
until I take it all apart, but now I'll be better prepared when I do
that.

--
Mark J. Blair, KE6MYK <mblair1@home.net>
PGP 2.6.2 public key available from http://www.keyserver.net/
Web page: http://www.qsl.net/ke6myk/
DO NOT SEND ANY UNSOLICITED COMMERCIAL EMAIL TO THIS SITE
PLEASE SEND PLAIN ASCII TEXT ONLY -- NO HTML OR QUOTED-PRINTABLE

Next message: Steve: "[MV] M35 wire"
Previous message: uniquemachine: "Re: [MV] Multifuel compressor pulley slipping"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Fri Dec 07 2001 - 00:36:59 PST