I used the stuff on the M38, 2 were recommended, I used 4.
The tank had lots of pin holes.
Did 2 coats in 2 days.
Used the kit with the chemicals, have the instructions in my Email files if
you need em.
It worked well, however in retrospect I wish I had taken the time to plug
the holes with JB Weld or something first.
I used Duck tape on the gauge and sender holes and a 4 folded trash bag
wrapped with a tarp strap on the neck.
Eastwoods has a kit and single bottles http://www.eastwoodco.com/
Rikk Rogers - RK Lion LTD.
(580)762-3157 rkltd@swbell.net
http://home.swbell.net/rkltd/
-M35A2- -M38- MVPA -22345-
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of JStinson90@aol.com
Sent: Tuesday, December 04, 2001 10:29 PM
To: Military Vehicles Mailing List
Subject: [MV] Gas Tank
Hey;
I'm trying to fix my Mutt gas tank. Just need to know if any one has
used the gas tank sealer from JC Whitney and is it worth it. ($30.00) Any
ideas on the easiest way to get the rust out? Am I supposed to use a rust
inhibitor before the gas tank sealer?
Jefferson C. Stinson
Your "JEEP" nut !!!!!!!
Jeff
MVPA Member # 18907
1971 M151A2 w/ROPS, heater w/ M4 pedistal & Cradle, M60 (dummy),
AN / VRC-47(radio), heater, fording kit.
1967 M416 trailer
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Sun Jan 06 2002 - 22:26:50 PST