Take the font you want to fast signs or quick signs
and they can make very cheap stencils that work better
than Ricks stuff.. only problem is they come out too
clean and good lookin to be real military HAHHA
Jess Minton
42 GPW
At 11:03 PM 12/9/01 -0500, you wrote:
>Fellow listers,
>I have used Rick Larsen's self-adhesive paint mask sets in the past to
>stencil the markings on my trucks, and have been very well pleased with their
>performance.
>BUT, I need to apply markings (stars, registration #, fuel acceptance rate,
>hood warnings, tire pressure, etc.) to three or four trucks, and quiet
>frankly I cannot afford to spend the money it takes to do this with these
>paint mask sets.
>Prior to using Rick's paint mask product, I have used the traditional oil
>board stencils, which are less expensive, but I have always had trouble with
>the paint blowing under the stencil, yielding a blurry line.
>Do any of ya'll have any suggestions?
>For what it is worth, I am marking M series 3/4, 2 1/2 and 5 ton trucks
>painted in the overall SG OD scheme.
>Thanks,
>David Doyle
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Sun Jan 06 2002 - 22:26:51 PST